Cylindrical Grinding of Al/Sic Metal Matrix Composites

Abstract
Keywords
Introduction
Materials and Methods
Results
Discussion
Conclusion
Acknowledgement
Funding Sources
Conflict of Interest
Data Availability Statement
Ethics Statement
References

Article | Open Access

Cylindrical Grinding of Al/Sic Metal Matrix Composites

Volume 7, Number 2

C.Thiagarajan¹*, R. Sivaramakrishnan² and S. Somasundaram³

¹Department of Production Engineering, St. Peter?s Engineering College, Chennai - 600 054 (India).

²Department of Production Technology, MIT Campus, Anna University Chennai - 600 044 (India).

³Department of Mechanical Engineering, National Institute of Technical Teachers Training and Research, Chennai - 600 113 (India).

DOI : http://dx.doi.org/10.13005/msri/070212

Download this article as:

ABSTRACT:

This paper deals with an experimental study on the grindability of Al/SiC metal matrix composites in cylindrical grinding. Machining of metal matrix composites (MMCs) is an area to be focused and finishing processes such as grinding to obtain a good surface finish and damage-free surfaces are crucial for the application of these materials. Nevertheless, grinding of MMCs has received little attention so far, thereby a detailed study on that has been carried out. In the present work, experiments are carried out to study the effect of grinding parameters; wheel velocity, work piece velocity, feed and depth of cut and SiC volume fraction percentage on the responses; grinding force, surface roughness and grinding temperature. Surface integrity of the ground surfaces is assessed using a scanning electron microscope (SEM). There are no cracks and defects found on the cylindrical ground surfaces at high wheel and work piece velocities, low feed and depth of cut.

KEYWORDS:

Metal matrix composites; SiC particles; Grinding force; Surface roughness; Grinding temperature

Article Metrics